Ford Transit Custom P2002: Why We Recommended DPF Replacement, Not Cleaning
· motorprokev
Vehicle: 2021 Ford Transit Custom, approximately 49,000 miles
Fault code: P2002 – Particulate Filter Efficiency Below Threshold (Bank 1)
Service: On-site mobile DPF fault diagnosis
Outcome: DPF and inlet pressure sensor replacement recommended
The customer’s problem
Precision Car Repairs visited the customer’s location to investigate a P2002 diesel particulate filter (DPF) efficiency fault. Rather than assuming the filter simply needed cleaning, we assessed the exhaust, checked the engine-management live data and carried out independent pressure tests.
First clue: soot in the tailpipe
Our initial physical inspection revealed soot inside the exhaust tailpipe, downstream of the DPF. A healthy DPF should trap the vast majority of soot, so this raised suspicion of internal filter damage or deterioration. Soot alone cannot prove a cracked filter, however, and further testing was needed.
What the live data showed
The ECU reported a DPF soot-loading calculation of 37% inferred closed loop and 98% inferred open loop. These are calculated values rather than direct measurements, and the difference warranted investigation. The EGR actual position was tracking its commanded position during our checks and the exhaust temperature readings were plausible.
Crucially, the DPF inlet pressure sensor’s voltage and pressure readings fluctuated. Those values did not neatly confirm our initial suspicion of internal DPF damage: they also raised the possibility that the sensor itself was misleading the ECU.
Checking regeneration history
The ECU recorded approximately 551 km (342 miles) since the last DPF regeneration. Other saved intervals were around 248 km and 264 km, with an average engine running time between regeneration events of approximately 505 minutes. These figures provided useful context, but could not establish the filter’s condition on their own.
Independent DPF pressure measurement
We attached a digital manometer to the filter pressure measurement point rather than relying exclusively on scan-tool information. During our test, the manometer recorded a peak of 172.5 mbar (17.25 kPa). This was an independent measurement, not an ECU reading, and encouraged us to investigate the accuracy of the installed pressure sensor further.
Testing the pressure sensor with a Mityvac
We then applied controlled pressure to the inlet pressure sensor using a Mityvac pump, comparing the applied pressure with the ECU’s live-data response. At lower pressures the sensor behaved reasonably; at higher applied pressures a marked discrepancy appeared. One high-pressure test recorded an ECU value of 84.8 kPa. This belongs to the separate sensor test and should not be treated as a simultaneous reading with the 172.5 mbar exhaust-pressure peak.
The sensor was therefore responsive, but not reliably accurate across the tested range — a fault that a quick code read or idle-only check could miss.
Diagnosis and recommendation
Taking together the P2002 efficiency fault, soot found downstream of the DPF and the independent test results, we found strong evidence of internal DPF deterioration or damage, alongside an inlet pressure sensor with inaccurate high-pressure readings. The precise nature of any internal filter damage was not confirmed by dismantling the DPF.
We explained that a DPF clean could be attempted but that cleaning would not repair a cracked or structurally damaged filter. Given the significant chance of the cleaning cost being wasted, we recommended putting the money towards replacing the DPF and pressure sensor instead. This records our recommendation, not a completed replacement.
Why diagnostics come before cleaning
A fault code tells us which condition the ECU detected, not necessarily which part to replace or which service to sell. On this Transit Custom, physical inspection, live data, regeneration history, independent back-pressure measurement and controlled sensor testing were all needed to reach an evidence-based recommendation.
Sometimes the right advice is not to buy the service we came to provide. Precision Car Repairs offers mobile vehicle diagnostics, DPF cleaning and suitable repairs at the customer’s location.
Need help with a DPF warning light or persistent vehicle fault? Contact Precision Car Repairs to request a mobile diagnostic assessment.
Read about our mobile diesel engine diagnostics and DPF assessment and cleaning.

Leave a Reply